Home › Engine / Hybrid System › B48 (EMISSION CONTROL) › MONOLITHIC CONVERTER
RM3650E _51 Engine / Hybrid System _080100 B48 EMISSION CONTROL _0388643 MONOLITHIC CONVERTER A

B48 EMISSION CONTROL  MONOLITHIC CONVERTER  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Hot exhaust system.

·

Risk of burning!

-

Any work must exclusively be carried out with an exhaust system that has cooled down.


·

Hot surfaces.

·

Risk of burning!

-

Perform all work only on components that have cooled down.




PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 12601B 2.REMOVE NO.1 ENGINE COVER SUB-ASSEMBLY

Hide 89467A 3.DISCONNECT WIDE RANGE AIR FUEL RATIO SENSOR

CAUTION:
·

Hot surfaces.

·

Risk of burning!

-

Perform all work only on components that have cooled down.




a.
A441803

Unlock plug connection (1) and disconnect.


b.

Disconnect the connector (2) from the carrier plate (3).


c.
A441802

Detach the cables (1) from the brackets (arrows).


Hide 89465 4.DISCONNECT OXYGEN SENSOR

CAUTION:
·

Hot surfaces.

·

Risk of burning!

-

Perform all work only on components that have cooled down.




a.
A441799

Unlock plug connection (1) and disconnect.


b.

Unscrew the bolts (2) from the carrier plate (3).


c.
A441800

Detach the cables (1) from the brackets (arrows).


d.

Loosen the monitoring sensor (1) using the special tools 0 493 751 (11 9 150) and 0 491 075 (11 7 030).


Hide 25051 6.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

CAUTION:
·

Hot exhaust system.

Risk of burning!



a.
A442384

Pull off the vacuum transmitting hose assembly (1).


b.
A442374

Unfasten nut (1).


c.

Loosen screw (2).


d.

Loosen screws (3).


e.

Guide out and remove holder (4).


f.
A442373

Loosen screw (1).


g.

Feed out V-band clamp (2) and remove.


h.

Pull out exhaust manifold converter sub-assembly (3) towards the bottom and remove.


Hide 89467A 7.REMOVE WIDE RANGE AIR FUEL RATIO SENSOR