Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Life-threatening injuries!
Observe safety information on raising the vehicle using a vehicle hoist.
For additional information see:
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>VEHICLE LIFT AND SUPPORT LOCATIONS
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT BRAKE DISC (for 4-Pot Caliper)
2.REMOVE FRONT BRAKE DISC (except 4-Pot Caliper)
48630
3.DISCONNECT FRONT UPPER SUSPENSION ARM ASSEMBLY
43502C
4.REMOVE FRONT AXLE HUB SUB-ASSEMBLY
| *a | Long "TORX" Socket Wrench |
Release the T60 bolts (1).
Remove front axle hub sub-assembly.