Home › Engine / Hybrid System › B58 (ENGINE MECHANICAL) › ENGINE WIRE HARNESS (for No. 1)
RM3650E _51 Engine / Hybrid System _080179 B58 ENGINE MECHANICAL _0388914 ENGINE WIRE HARNESS(for No. 1) A

B58 ENGINE MECHANICAL  ENGINE WIRE HARNESS(for No. 1)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.

-

For an auxiliary battery: Disconnect battery earth lead of auxiliary battery.




NOTICE:
·

Damage to battery terminal, the safety battery terminal or the intelligent battery sensor (IBS).

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.




PROCEDURE

Hide 51219 1.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 12140 2.REMOVE OIL PAN COVER

Hide 82121 4.REMOVE ENGINE WIRE

Overview: Engine wire
A442180

NOTICE:
·

Damage to wires when disconnecting connectors and plug connections.

Sheared wires can cause a short circuit.

-

Do not pull on the wires when disconnecting connectors and plug connections.




a.
A442181

Remove connector (1) from the No. 1 integration relay.


b.

Remove connector (2) from the ECM.


c.

Unlock and loosen the connector (3) of the vacuum sensor assembly.


d.
A442182

Unlock and detach the connector (1) of the water pump assembly (for Turbo).


e.

Unlock and disconnect the connector (2) of the No. 2 engine wire.


f.

Unlock and loosen the connector (3) of the air pressure sensor.


g.

Unlock and disconnect the connector (4) of the inlet air temperature sensor.


h.
A442183

Unlock and disconnect the connector (1) of the throttle body with motor assembly.


i.

Unlock and disconnect the connector (2) of the generator assembly.


j.

Unlock and disconnect the connector (3) of the knock sensor of cylinders 1 to 3.


k.

Unlock and disconnect the connector (4) of the water valve with bracket assembly.


l.

Unlock and disconnect the lower connector (5) of the water valve with bracket assembly.


m.

Unlock and disconnect the connector (6) of the knock sensor of cylinders 4 to 6.


n.
A442177

Loosen E8 bolts (1).


o.

Loosen clamp (2).


p.

Detach positive battery cable from bracket (3).


q.

Release cable duct (4) and lay to one side.


r.
A442184

Unlock and disconnect the connector (1) of the oil temperature sensor.


s.

Unlock and disconnect the connector (2) of the oil pressure sensor.


t.

Unlock and disconnect the connector (3) of the oil pressure control valve assembly.


u.

Unlock and disconnect the connector (4) of the crankshaft position sensor.


v.

Loosen T30 bolts (5).


w.
A442185

Unlock and disconnect the connector (1) of the engine oil level sensor.


x.

Unlock and detach all clamps.


y.

Feed out the engine wire and remove it.