Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SEAT POSITION SENSOR
RM3650E _58 Vehicle Interior _079907 SUPPLEMENTAL RESTRAINT SYSTEMS _0390130 SEAT POSITION SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SEAT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
B475753

Pyrotechnic components.

Danger! Life-threatening injuries!

-

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.

-

Replace any damaged part or ones that have been dropped.



·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach the cable from the negative (-) battery terminal.



·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:
·

Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.

·

When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.

·

Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.



HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY

Hide 2.REMOVE SEAT POSITION AIRBAG SENSOR (for Manual Seat)

a.
B539399

Loosen the tie band (1).


b.

Detach the claws (4) carefully.


c.

Remove the connector (2) in the direction of the arrow from the connector housing (3).


d.
B538774

Remove the connectors in order from (1) to (2) and pull them out of the connector housing (3) one after another in the direction of the arrow.


e.
B538777

Detach the clamps (1).


f.
B538798

Loosen bolt (1).


g.

Pull the No. 2 seat position airbag sensor (2) out up of the front seat adjuster assembly (3) upwards and remove.


Hide 3.REMOVE SEAT POSITION AIRBAG SENSOR (for Power Seat)

a.
B538800

Loosen the tie band (1).


b.

Detach the claws (4) carefully.


c.

Remove the connector (2) in the direction of the arrow from the connector housing (3).


d.
B538799

Remove the connectors in order from (1) to (2) and pull them out of the connector housing (3) one after another in the direction of the arrow.


e.
B538802

Detach the clamp (1).


f.
B538801

Loosen bolt (1).


g.

Pull the seat position airbag sensor (2) out up of the front seat adjuster assembly (3) upwards and remove.