Home › Engine / Hybrid System › B48 (COOLING) › RADIATOR (for High Temperature)
RM3650E _51 Engine / Hybrid System _080127 B48 COOLING _0391998 RADIATOR(for High Temperature) A

B48 COOLING  RADIATOR(for High Temperature)  REMOVAL  


PROCEDURE

Hide 16360A 1.REMOVE FAN WITH MOTOR ASSEMBLY

Hide 51219 2.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 3. DRAIN ENGINE COOLANT (for High Temperature)

Hide 16400 4.REMOVE RADIATOR ASSEMBLY

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




NOTICE:
·

Life-long fill of coolant!

·

Do not reuse used coolant.

When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.

In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.

·

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.



a.
A442318

Loosen T30 screws (1).


b.

Unlock the lock (2) and remove the radiator upper air guide plate (3) toward the top.


c.
A442328

Unlock the No. 2 radiator hose (1) and disconnect from the radiator assembly.


d.
A442329

Unlock plug connection (1) and disconnect.


e.
A442330

Loosen T30 screw (1).


f.
A442331

Slightly pivot the radiator assembly (1) in direction of arrow and thread out and remove to the top.