61758D
1.INSTALL PIVOT MOUNTING SUPPORT LH
Perform this procedure only when replacement of the pivot mounting support LH is necessary.
Install the pivot mounting support LH (2) with the bolts (1).
61757D
2.INSTALL PIVOT MOUNTING SUPPORT RH
Perform this procedure only when replacement of the pivot mounting support RH is necessary.
Use the same procedure as for the LH side.
64718A
3.INSTALL DECK TRIM SERVICE HOLE COVER
Perform this procedure only when replacement of the deck trim service hole cover is necessary.
Position the deck Trim service hole cover and close.
Turn the screw cap counterclockwise and lock.
64230A
4.INSTALL ROOM PARTITION NET ASSEMBLY (w/ Courtesy Light)
Perform this procedure only when replacement of the room partition net assembly is necessary.
|
Install in this Direction |
Attach the guide (3).
Attach the guide (2).
Attach the guides (1) to install the room partition net assembly (4) in the direction of the arrow.
Attach the clip (1).
5.INSTALL ROOM PARTITION BAND ASSEMBLY (w/ Courtesy Light)
Perform this procedure only when replacement of the room partition band assembly is necessary.
Attach the guides (2) and claws (1) to install the room partition band assembly (3).
64715C
6.INSTALL DECK SIDE TRIM COVER LH
Perform this procedure only when replacement of the deck side trim cover LH is necessary.
Attach the guides (2).
Attach the claws (1) to install the deck side trim cover LH (3) in the deck trim side board LH.
64714C
7.INSTALL DECK SIDE TRIM COVER RH
Perform this procedure only when replacement of the deck side trim cover RH is necessary.
Use the same procedure as for the LH side.
64034A
8.INSTALL REAR SPEAKER GRILLE SUB-ASSEMBLY LH
Perform this procedure only when replacement of the rear speaker grille sub-assembly LH is necessary.
|
Front Side |
Attach the guide (2) and clips (1) to install the rear speaker grille sub-assembly LH (2).
64033A
9.INSTALL REAR SPEAKER GRILLE SUB-ASSEMBLY RH
Perform this procedure only when replacement of the rear speaker grille sub-assembly RH is necessary.
Use the same procedure as for the LH side.
86160B
10.INSTALL REAR SPEAKER ASSEMBLY
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
Position the rear speaker assembly LH (2).
Tighten nuts (1).
Attach the clamps (2).
Connect connector (1) and lock.
64717E
11.INSTALL LUGGAGE COMPARTMENT TRIM FRONT COVER
Attach the guides (4), guides (3) and clips (2) to install the luggage compartment trim front cover (1).
Tighten nuts (1).
Attach the clip (1) in the luggage compartment trim front cover (2).
w/ extinguisher:
Attach the strap to install the extinguisher.
72996K
12.INSTALL CHILD RESTRAINT SEAT COVER
Use the same procedures for the opposite side.
Attach the guides (2) and claws (1) to install the child restraint seat cover (3).
86160Z
13.INSTALL REAR NO. 3 SPEAKER ASSEMBLY (for 12 Speakers)
86160Y
14.INSTALL REAR NO. 2 SPEAKER ASSEMBLY (for 10 Speakers)
Use the same procedure as for the No. 3 speaker.
15.INSTALL QUARTER TRIM LOWER PANEL LH
Attach the guides (4) to install the quarter trim lower panel LH (3).
Attach the clip (2).
Tighten nut (1).
16.INSTALL QUARTER TRIM LOWER PANEL RH
Use the same procedure as for the LH side.
67914
17.INSTALL FRONT DOOR SCUFF PLATE LH
67913
18.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
64285C
19.INSTALL LUGGAGE COMPARTMENT TRIM REAR COVER
Attach the clips (3) to install the luggage compartment trim rear cover (2).
Attach the clip (1).
64740B
20.INSTALL DECK TRIM SIDE BOARD AND DECK SIDE TRIM COVER LH
Insert the deck trim side board and deck side trim cover LH (4).
Guide the deck trim side board and deck side trim cover LH (4) into the upper rear area under the back door weatherstrip.
Attach the clips (3).
Attach the clip (2).
Tighten the T20 screws (1).
64730C
21.INSTALL DECK TRIM SIDE BOARD AND DECK SIDE TRIM COVER RH
Insert the deck trim side board and deck side trim cover RH (4).
w/ Courtesy Light:
Connect connector (5) and lock.
Guide the deck trim side board and deck side trim cover RH (4) into the upper rear area under the back door weatherstrip.
Attach the clips (3).
Attach the clip (2).
Tighten the T20 screws (1).
66311
22.INSTALL ROPE HOOK (w/ Courtesy Light)
Use the same procedures for the opposite side.
|
Close in this Direction |
Replace rope hooks (4).
Install the rope hooks (4) with the T40 bolts (3).
Attach the claws (1) to close the covers (2) in the direction of the arrow.
81330
23.INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
64716D
24.INSTALL DECK TRIM REAR COVER
Guide in the deck trim rear cover (3) under the back door weatherstrip to attach the clips (4).
Attach the clips (2).
Tighten the T30 screws.
Attach the claws (2) to install the back door striker cover (1).
81604
25.INSTALL TRIANGLE REFLECTOR SET
Install the triangle reflector set (2) and secure it with hook and loop fastener (1).
Close the lid of the triangle reflector set (2) and lock the screw caps (1).
Perform this procedure only when the lid has been opened.
62636A
26.INSTALL QUARTER TRIM UPPER PANEL LH
62635A
27.INSTALL QUARTER TRIM UPPER PANEL RH
Use the same procedure as for the LH side.
62420A
28.INSTALL CENTER PILLAR GARNISH ASSEMBLY LH
62410A
29.INSTALL CENTER PILLAR GARNISH ASSEMBLY RH
Use the same procedure as for the LH side.
64277L
30.INSTALL TRANSVERSE PIPE
62609
31.INSTALL SEAT BELT HOLE COVER SUB-ASSEMBLY LH
62608
32.REMOVE SEAT BELT HOLE COVER SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
64288D
33.INSTALL TRANSVERSE PIPE TRIM
62480A
34.INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH
62470A
35.INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH
Use the same procedure as for the LH side.
64711B
36.INSTALL DECK BOARD ASSEMBLY
|
Install in this Direction |
Slide the left edge of the deck board assembly (1) into the recess in the direction of the arrow of the deck board assembly.
Pivot deck board assembly (1) in the direction of the arrow and position centered in the vehicle.
w/ Spare Tire:
Attach the straps (1) to install the spare wheel cover (2).
64330D
37.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
38.INSTALL CONSOLE BOX ASSEMBLY