Working on fuel system.
Risk of fire! Danger of explosion!
When working on the fuel system, make sure that the workbay is sufficiently ventilated, e.g. using extraction unit.
Tightly seal off open lines and connections; collect any escaping fuel directly at the point of exit.
No fire, sparks, open flames or smoking.
Contact with hazardous fluids.
Hazardous to health!
Note and follow safety information on containers.
Conduct all work in appropriate personal protective equipment only.
58166A
1.REMOVE FRONT FLOOR COVER LH
50819
2.REMOVE FRONT FLOOR COVER
77255
3.REMOVE NO. 2 FUEL EMISSION TUBE
Unlock and disconnect snap fastener (1).
Unlock and disconnect snap fastener (2).
Unclip No. 2 fuel emission tube (3) from the brackets (4) and remove.