1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>B58 BATTERY>REMOVAL
2.REMOVE SAFETY BATTERY TERMINAL
Working on 12 V vehicle electrical system.
Risk of short circuits! Risk of fire!
Disconnect the cable from the negative (-) battery terminal.
Damage to battery terminal, the safety battery terminal or the battery state sensor.
Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.
Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.
Electrostatic discharge.
Damage to or destruction of electrical components.
Leave electrical components in original packaging until just before they are installed. Use the original packaging only for any return shipments. Always package removed components straight away.
Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.
Anti static work clothing and antistatic shoes (with ESD symbol).
For additional information see:
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Loosen the latch mechanisms(2).
Remove the protective cap(1) upwards.
Loosen the holder (1).
Unlock and disconnect connectors (2).
Put the cable (3) to one side.
Loosen the holder (1).
Put the cable (2) to one side.
Unclip the cover (1) in the marked areas.
Release and remove the cover (1).
Unfasten nut (1).
Remove No. 4 floor wire (2).
Open the cover (1) of the safety battery terminal.
Release the nut (1) and put the No. 4 floor wire (2) aside.
Loosen the holder (1).
Release nut (2) and remove the safety battery terminal (3).