Hot fluids.
Risk of scalding!
Conduct all work in the vehicle wearing appropriate personal protective equipment only.
Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
| *A | for 2 Port Type |
| *B | for 6 Port Type |
Check the shape of the Turbo Charger SUB-ASSY before doing removal/installation work.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
17201
1.REMOVE TURBOCHARGER SUB-ASSEMBLY
16028
2.REMOVE NO. 2 TURBO WATER PIPE SUB-ASSEMBLY (for 2 Port Type)
16028
3.REMOVE NO. 2 TURBO WATER PIPE SUB-ASSEMBLY (for 6 Port Type)
15407
4.REMOVE INLET TURBO OIL PIPE SUB-ASSEMBLY (for 2 Port Type)
Hot fluids.
Risk of scalding!
Conduct all work in the vehicle wearing appropriate personal protective equipment only.
Have a rag ready and catch any engine oil that may emerge.
Pull off the inlet turbo oil pipe sub-assembly (1).
15407
5.REMOVE INLET TURBO OIL PIPE SUB-ASSEMBLY (for 6 Port Type)
Hot fluids.
Risk of scalding!
Conduct all work in the vehicle wearing appropriate personal protective equipment only.
Have a rag ready and catch any engine oil that may emerge.
Pull off the inlet turbo oil pipe sub-assembly (1).