Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Separate Seat Type Front Passenger Side)

FRONT SEAT ASSEMBLY (for Separate Seat Type Front Passenger Side) > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).



1. INSTALL FRONT SEAT ASSEMBLY


    B087392E02
  1. Place the front seat in the cabin.

  1. Tighten the 2 bolts on the front side of the front seat.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Tighten the 2 bolts on the rear side of the front seat.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }



    B087647E01
  1. Install the wire harness clamp.

  1. Connect the connector.

  1. w/ Front Seat Side Airbag:

    1. Connect the connector.



2. INSTALL SEAT TRACK COVER


B087345E01

HINT:
Follow the same procedures as for the opposite side.

  1. Engage the 2 claws and install the seat track cover.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



4. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)
(Click here)