ENGINE REAR OIL SEAL > INSTALLATION |
| 1. INSTALL REAR ENGINE OIL SEAL |
![]() |
Apply MP grease to a new oil seal tip.
Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
| 2. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission) |
![]() |
Using SST, hold the crankshaft.
![]() |
Apply adhesive to 2 or 3 threads of the mounting bolt end.
![]() |
Install the flywheel and 2 spacers onto the crankshaft.
Using several steps, uniformly install and tighten the 8 mounting bolts in the sequence shown in the illustration.
| 3. INSTALL DRIVE PLATE & RING GEAR SUB-ASSEMBLY (for Automatic Transmission) |
![]() |
Using SST, hold the crankshaft.
![]() |
Apply adhesive to 2 or 3 threads of the mounting bolt end.
![]() |
Install the drive plate and 2 spacers onto the crankshaft.
Using several steps, uniformly install and tighten the 8 mounting bolts in the sequence shown in the illustration.
| 4. INSTALL TRANSMISSION ASSEMBLY |
| Transmission | Drive Type | See Page |
| Manual Transmission | 2WD |
Click here
|
| Manual Transmission | 4WD |
Click here
|
| Automatic Transmission | 2WD |
Click here
|
| Automatic Transmission | 4WD |
Click here
|