ENGINE REAR OIL SEAL > REMOVAL |
| 1. REMOVE TRANSMISSION ASSEMBLY |
| Transmission | Drive Type | See Page |
| Manual Transmission | 2WD |
Click here
|
| Manual Transmission | 4WD |
Click here
|
| Automatic Transmission | 2WD |
Click here
|
| Automatic Transmission | 4WD |
Click here
|
| 2. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission) |
![]() |
Using SST, hold the crankshaft.
![]() |
Remove the 8 bolts, then remove the flywheel and 2 spacers.
| 3. REMOVE DRIVE PLATE & RING GEAR SUB-ASSEMBLY (for Automatic Transmission) |
![]() |
Using SST, hold the crankshaft.
![]() |
Remove the 8 bolts, then remove the drive plate and 2 spacers.
| 4. REMOVE REAR ENGINE OIL SEAL |
![]() |
Using a knife, cut off the oil seal lip.
Using a screwdriver, pry out the oil seal.