ENGINE REAR OIL SEAL > INSTALLATION |
| 1. INSTALL ENGINE REAR OIL SEAL |
![]() |
Apply a light coat of MP grease to the lip of a new oil seal.
Using SST and a hammer, tap the oil seal in until its surface is flush with the rear oil seal retainer edge.
| 2. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission) |
![]() |
Clean the 10 bolts and 10 bolt holes.
Apply adhesive to 2 or 3 threads of the 10 bolts.
Using SST, hold the crankshaft.
![]() |
Using several steps, uniformly install and tighten the 10 bolts in the sequence shown in the illustration.
![]() |
Mark the bolts with paint as shown in the illustration.
Retighten the bolts by 90° in the same sequence as in step (d).
Check that the paint mark of each bolt is at a 90° from the original position.
| 3. INSTALL DRIVE PLATE and RING GEAR SUB-ASSEMBLY (for Automatic Transmission) |
![]() |
Clean the 10 bolts and 10 bolt holes.
Apply adhesive to 2 or 3 threads of the 10 bolts.
Provisionally install the drive plate spacer front, drive plate and ring gear and drive plate rear with the 10 bolts.
Using SST, hold the crankshaft.
![]() |
Using several steps, uniformly install and tighten the 10 bolts in the sequence shown in the illustration.
| 4. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission) |
| Transmission | See page |
| R155 |
Click here
|
| R155F |
Click here
|
| 5. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission) |
| Transmission | See page |
| R155 |
Click here
|
| R155F |
Click here
|
| 6. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY |
| Transmission | See page |
| R155 |
Click here
|
| R155F |
Click here
|
| 7. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY |
| 8. CHECK FOR ENGINE OIL LEAKAGE |