Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SEAT POSITION SENSOR (for Separate Seat Type)

SEAT POSITION SENSOR (for Separate Seat Type) > ON-VEHICLE INSPECTION

for Preparation Click here



1. SEAT POSITION SENSOR (for Vehicle not Involved in Collision)
  1. Perform a diagnostic system check (Click here).



2. SEAT POSITION SENSOR (for Vehicle Involved in Collision)
  1. Perform a diagnostic system check (Click here).

  1. Even if the airbag was not deployed, perform a visual check for damage to the seat position sensor. If there are any defects as mentioned below, replace the seat position sensor with a new one:

    1. Cracks, dents or chips in the case.
    2. Cracks or other damage to the connector.

      CAUTION:
      For removal and installation procedures of the seat position sensor, Click here, Click here, and be sure to follow the correct procedure.