SFI SYSTEM > VC Output Circuit |

| 1.CHECK MIL |
Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch ON.
|
| ||||
| NG | |
| 2.CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM |
Connect an intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Check the communication between an intelligent tester and ECM.
| Result | Proceed to |
| Communication is possible | A |
| Communication is not possible | B |
|
| ||||
| B | |
| 3.CHECK MIL (THROTTLE BODY) |
Disconnect the throttle body connector.
Turn the ignition switch ON.
Check the MIL.
| Result | Proceed to |
| MIL illuminates | A |
| MIL does not illuminate | B |
Reconnect the throttle body connector.
|
| ||||
| B | |
| 4.CHECK MIL (ACCELERATOR PEDAL) |
Disconnect the accelerator pedal connector.
Turn the ignition switch ON.
Check the MIL.
| Result | Proceed to |
| MIL illuminates | A |
| MIL does not illuminate | B |
Reconnect the accelerator pedal connector.
|
| ||||
| B | |
| 5.CHECK MIL (CANISTER PUMP MODULE) |
Disconnect the canister pump module connector.
Turn the ignition switch ON.
Check the MIL.
| Result | Proceed to |
| MIL illuminates | A |
| MIL does not illuminate | B |
Reconnect the canister pump module connector.
|
| ||||
| B | |
| 6.CHECK HARNESS AND CONNECTOR |
Disconnect the throttle body connector.
Disconnect the accelerator pedal connector.
Disconnect the canister pump module connector.
![]() |
Disconnect the ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| VC (E4-23) - Body ground | 10 kΩ or higher |
| VCPA (E8-26) - Body ground | |
| VCP2 (E8-27) - Body ground |
Reconnect the throttle body connector.
Reconnect the accelerator pedal connector.
Reconnect the canister pump module connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||