Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1337/37    Different Diameter Tire Malfunction

for Preparation Click here


DESCRIPTION

The skid control ECU measures the speed of each wheel by receiving signals from the speed sensors. These signals are used for recognizing whether all 4 wheels are operating properly. Therefore, all wheel signals must be equal.

DTC No.
DTC Detecting Condition
Trouble Areas
C1337/37
When either one of following condition detected:
  1. Diameters different of 2 front wheels and 2 rear wheels.
  2. Wheel speed sensor fault
  1. Speed sensor
  2. Speed sensor rotor
  3. Speed sensor circuit
  4. Tire sizes

INSPECTION PROCEDURE

NOTICE:
Check the speed sensor signal after replacement (Click here).

1.CHECK TIRE SIZE
  1. Check tire size and condition of all 4 wheels.

    OK:
    All 4 wheels are the same size and in the same condition.



NG
REPLACE TIRES SO THAT ALL 4 TIRES ARE SAME IN SIZE
OK


2.CHECK SPEED SENSOR ROTOR
Click here
  1. Remove the drive shaft, and check around the speed sensor rotor.

    OK:
    No scratches or foreign matter on the sensor tip.



NG
REPLACE SPEED SENSOR ROTOR
OK


3.CHECK SPEED SENSOR
  1. Check the speed sensor circuit (Click here).



NG
REPLACE SPEED SENSOR
OK


4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - EACH SPEED SENSOR)
  1. Check the speed sensor circuit (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Drive the vehicle at more than 13 mph (20 km/h) for more than 60 seconds.

  1. Check if the same DTCs are detected.

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID