Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1251/51    Open in Pump Motor Circuit

for Preparation Click here


DESCRIPTION

The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU.

DTC No.
DTC Detecting Condition
Trouble Areas
C1251/51
Open in motor system circuit (motor input circuit)
Hydraulic brake booster pump motor circuit

WIRING DIAGRAM


C124775E01


INSPECTION PROCEDURE

HINT:
Remove the hydraulic brake booster before the inspection (Click here).

1.CHECK BRAKE PUMP MOTOR WIRE HARNESS CONNECTION (MT+ / MT-)
  1. Using a screwdriver, remove the 2 plugs from the hydraulic brake booster .

  1. Check the tightening torque of 2 screws which fasten the wire harness connecting hydraulic brake booster and brake booster pump .

Torque:
2.9 N*m{ 30 kgf*cm , 26 in.*lbf }



NG
RETIGHTEN SCREWS
OK


2.CHECK RESISTANCE OF PUMP MOTOR WIRE HARNESS (MT+/MT-)


    F052356E02
  1. Using a screwdriver, remove the 2 screws and pull the wire harness from the hydraulic brake booster.

  1. Measure the resistance between the red wire (MT+) and black wire (MT-).

    Resistance:
    2 Ω



NG
REPLACE HYDRAULIC BRAKE BOOSTER
OK


3.RECONFIRM DTC
  1. Reassemble the hydraulic brake booster, then reinstall the hydraulic brake booster.

  1. Clear the DTCs (Click here).

  1. Check if the same DTCs are detected.

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID