OCCUPANT CLASSIFICATION ECU (for Bench Seat Type) > REMOVAL |
| 1. READ IN OCCUPANT CLASSIFICATION ECU DATA |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Store the occupant classification ECU data into the intelligent tester by following the prompts on the tester screen.
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Replace the occupant classification ECU (Click here).
Connect the negative (-) terminal cable to the battery.
Turn the ignition switch to the ON position.
Load the data from the previous ECU stored in the tester, into the newly installed ECU by following the prompts on the tester screen.
Turn the ignition switch to the LOCK position.
Turn the ignition switch to the ON position.
Clear the DTCs stored in the memory (Click here).


| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH |
![]() |
Slide the front seat to the most forward position.
Disengage the hook.
Disconnect the 2 connectors.
Using a clip remover, remove the wiring harness clamp.
Remove the wiring harness clamp.
Remove the bolt and the front seat inner belt.
| 4. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH |
![]() |
Slide the front seat to the most forward position.
Disengage the hook.
Disconnect the connector.
Using a clip remover, remove the wiring harness clamp.
Remove the wiring harness clamp.
Remove the bolt and the front seat inner belt.
| 5. REMOVE FRONT SEAT HEADREST ASSEMBLY |
![]() |
Push in the 2 lock buttons of the 2 front seat headrest supports and remove the 2 front seat headrests.
| 6. REMOVE FRONT SEAT ASSEMBLY |
![]() |
Remove the belt of the front center seat outer belt from the front center seat outer belt guide.
![]() |
Disconnect the 3 connectors.
Using a clip remover, remove the 2 wiring harness clamps.
![]() |
Remove the 4 bolts and the front seat.
| 7. REMOVE OCCUPANT CLASSIFICATION ECU |
![]() |
Disconnect the connector from the the occupant classification ECU.
Remove the 2 bolts and the occupant classification ECU.