Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Light Circuit

for Preparation Click here


DESCRIPTION

If the tire pressure warning ECU detects a malfunction, the tire pressure warning light comes on and the tire pressure monitor is cancelled simultaneously. At this time, the ECU stores DTCs in the memory. Connecting terminals TC and CG of the DLC3 causes the tire pressure warning light to blink and output DTCs.

WIRING DIAGRAM


C122906E01


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the ECU using the intelligent tester and note them down before removal (Click here ).
  2. It is necessary to perform initialization (Click here) after registration (Click here ) the transmitter IDs into the tire pressure warning ECU after the tire pressure warning ECU and/or tire pressure warning valve and transmitter have been replaced.

1.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU - COMBINATION METER)


    C124992E02
  1. Disconnect the connectors from the tire pressure warning ECU and combination meter.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    IND (T14-6) - IND (C9-23)
    Below 1 Ω
    IND (T14-6) - Body ground
    10 kΩ or higher

  1. Reconnect the connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT COMBINATION METER
  1. Disconnect the connector from the tire pressure warning ECU.

  1. Turn the ignition switch to the ON position, check the condition of the tire pressure warning light illumination.

    Result:
    Condition
    Proceed to
    Illuminates
    A
    Does not illuminate
    B



B
REPLACE COMBINATION METER
A

REPLACE TIRE PRESSURE WARNING ECU