Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2176/76    Receiver Error

for Preparation Click here


DESCRIPTION

The signals are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU.

DTC No.
DTC Detection Condition
Trouble Area
C2176/76
When either of following detected:
  1. EEPROM in tire pressure warning ECU malfunction
  2. Terminal RF5V shorted to ground
  1. Tire pressure warning antenna and receiver
  2. Tire pressure warning ECU
  3. Wire harness or connector

WIRING DIAGRAM


C122903E01


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the ECU using the intelligent tester and note them down before removal (Click here ).
  2. It is necessary to perform initialization (Click here) after registration (Click here ) the transmitter IDs into the tire pressure warning ECU after the ECU have been replaced.

1.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU - TIRE PRESSURE WARNING RECEIVER)


    C124991E01
  1. Disconnect the connectors from the tire pressure warning antenna and receiver and tire pressure warning ECU.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    RDA (T14-7) - RDA (T16-1)
    Below 1 Ω
    RF5V (T14-8) - +5V (T16-5)
    Below 1 Ω
    GND2 (T14-16) - GND (T16-4)
    Below 1 Ω
    RDA (T14-7) - Body ground
    10 k Ω or higher
    RF5V (T14-8) - Body ground
    10 k Ω or higher
    GND2 (T14-16) - Body ground
    10 k Ω or higher

  1. Reconnect the connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT TIRE PRESSURE WARNING ECU
  1. Turn the ignition switch to the ON position.



    C117152E12
  1. Measure the voltage of the terminals between RF5V and GND2 of the tire pressure warning ECU.

    Standard voltage:
    Tester Connection
    Specified Condition
    GND2 (T14-16) - RF5V (T14-8)
    4.5 to 5.5 V



NG
REPLACE TIRE PRESSURE WARNING ECU
OK


3.INSPECT TIRE PRESSURE WARNING ECU
  1. Replace the tire pressure warning ECU with a normally functioning or new one.

  1. Register the transmitter IDs again (Click here ).

  1. Perform TEST MODE PROCEDURE (Click here ).

  1. Perform the forcible transmission of all the transmitter IDs.

  1. Confirm that DTCs C2181/81 to C2185/85 are cleared.

    Result:
    Result
    Proceed to
    DTCs all cleared
    A
    DTCs not cleared
    B



A
REPLACE TIRE PRESSURE WARNING ECU
B

REPLACE TIRE PRESSURE WARNING ANTENNA AND RECEIVER