Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2177/77    Initialization not Completed

for Preparation Click here


DESCRIPTION

The initialization procedure starts when the tire pressure warning reset switch is pressed for 3 seconds or more with the ignition switch in the ON position.
The tire pressure warning ECU registers the tire pressure data by the signals from the tire pressure warning valve and transmitter, and start the tire pressure warning light blinking 3 times at 1 second intervals.

DTC No.
DTC Detection Condition
Trouble Area
C2177/77
Initialization not complete after vehicle driven at 5 mph (8 km/h) or more for total of 20 minutes or more.
  1. Tire pressure warning valve and transmitter
  2. Tire pressure warning ECU

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the ECU using the intelligent tester and note them down before removal (Click here ).
  2. It is necessary to perform initialization (Click here) after registration (Click here ) the transmitter IDs into the tire pressure warning ECU after the tire pressure warning ECU and/or tire pressure warning valve and transmitter have been replaced.

1.CHECK DTC
  1. Check for DTCs (Click here ).

    Result:

    Result
    Proceed to
    DTC C2177 output with another DTCs
    A
    Only DTC C2177 output
    B

    HINT:
    1. When the tire pressure warning ECU receives no signals for several minutes after the initialization procedure has finished, a DTC is output.
    2. When only DTC C2177 is output, refer to the other troubleshooting procedure (Click here ).



B
GO TO OTHER PROBLEM (MALFUNCTION IN TRANSMISSION OR RECEPTION)
A

INSPECTION PROCEDURE RELEVANT TO OUTPUT DTC