SFI SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
| NORMAL MODE AND CHECK MODE |
| 2 TRIP DETECTION LOGIC |
| FREEZE FRAME DATA |
| DLC3 (Data Link Connector 3) |
![]() |
| Symbol | Terminal No. | Name | Reference Terminal | Result | Condition |
| SIL | 7 | Bus "+" line | 5 - Signal ground | Pulse generation | During transmission |
| CG | 4 | Chassis ground | Body ground | 1 Ω or less | Always |
| SG | 5 | Signal ground | Body ground | 1 Ω or less | Always |
| BAT | 16 | Battery positive | Body ground | 11 to 14 V | Always |
| CANH | 6 | CAN "High" line | CANL | 54 to 69 Ω | Ignition switch off*
|
| CANH | 6 | CAN "High" line | Battery positive | 1 MΩ or higher | Ignition switch off*
|
| CANH | 6 | CAN "High" line | CG | 200 Ω or higher | Ignition switch off*
|
| CANL | 14 | CAN "Low" line | Battery positive | 1 MΩ or higher | Ignition switch off*
|
| CANL | 14 | CAN "Low" line | CG | 200 Ω or higher | Ignition switch off*
|
| BATTERY VOLTAGE |
| MIL (Malfunction Indicator Lamp) |
The MIL is illuminated when the ignition switch is first turned to ON (the engine is not running).
The MIL should turn off when the engine is started. If the MIL remains illuminated, the diagnosis system has detected a malfunction or abnormality in the system.
| ALL READINESS |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear DTCs (Click here).
Turn the ignition switch to off and wait for at least 30 seconds.
Perform the DTC judgment driving pattern to run the DTC judgment.
Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.
Input the DTCs to be confirmed.
Check the DTC judgment result.
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|