Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > MIL Circuit

for Preparation Click here


DESCRIPTION

The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunction detections by the ECM.
By turning the ignition switch to ON, power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL.
The MIL operation can be checked visually: When the ignition switch is first turned to ON, the MIL should be illuminated and should then turn OFF. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the Techstream.

WIRING DIAGRAM


A237104E02


INSPECTION PROCEDURE

1.CHECK THAT MIL IS ILLUMINATED
  1. Perform troubleshooting in accordance with the chart below.

Result 
Result
Proceed to
MIL remains ON
A
MIL does not illuminate
B


B
Go to step 4
A


2.CHECK WHETHER MIL TURNS OFF
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Check whether any DTCs have been stored (Click here). Note them down if necessary.

  1. Clear DTCs (Click here).

  1. Check if the MIL turns OFF.

    OK:
    MIL should turn off.



OK
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
NG


3.CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS)
A065744E07
  1. Disconnect the ECM connector.

  1. Turn the ignition switch to ON.

  1. Check that the MIL is not illuminated.

    OK:
    MIL is not illuminated.

  1. Reconnect the ECM connector.



OK
REPLACE ECM (Click here)
NG

CHECK AND REPLACE HARNESS AND CONNECTOR 

4.CHECK THAT MIL IS ILLUMINATED
  1. Check if the MIL is illuminated when the ignition switch is turned to ON.

    OK:
    MIL should be illuminated.



OK
END
NG


5.CHECK THAT ENGINE STARTS
  1. Turn the ignition switch to ON

  1. Start the engine.

Result 
Result
Proceed to
Engine starts
A
Engine does not start*
B

HINT:
*: The Techstream cannot communicate with the ECM.



B
GO TO VC OUTPUT CIRCUIT (Click here)
A


6.INSPECT COMBINATION METER ASSEMBLY (MIL CIRCUIT)
  1. See the combination meter troubleshooting procedure (Click here).



NG
REPAIR OR REPLACE BULB OR COMBINATION METER ASSEMBLY
OK

CHECK AND REPLACE HARNESS OR CONNECTOR (COMBINATION METER ASSEMBLY - ECM)