Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the cruise control system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the Techstream to check if the CAN communication system is functioning normally.
      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4.CHECK FOR DTC*
    1. Check for DTCs (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the cruise control system DTCs by simulating the conditions indicated by the DTCs.
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    5.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Road Test (Click here)

    2. Terminals of ECM (Click here)

    3. Data List / Active Test (Click here)


    NEXT


    7.ADJUST, REPAIR OR REPLACE

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END