Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit

for Preparation Click here


DESCRIPTION

  1. When the ECM detects a cruise control switch on signal from the cruise control switch, the ECM sends the signal to the combination meter assembly through CAN communication. Then the cruise control indicator light turns on.
  2. The cruise control indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (CRUISE MAIN INDICATOR LIGHT)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. According to the display on the Techstream, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp Cruise
    Cruise main indicator light
    ON/OFF
    Confirm that the vehicle is stopped with the engine idling.

    OK:
    Cruise main indicator light turns on/off.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2.READ VALUE USING TECHSTREAM (CRUISE CONTROL SWITCH)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Powertrain / Cruise Control / Data List.

  1. According to the display on the Techstream, read the Data List.

    Cruise Control 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Main SW M-CPU
    Cruise control switch (Main CPU) / OFF or ON
    OFF: Cruise control switch off
    ON: Cruise control switch on
    -

    OK:
    On screen, item changes between ON and OFF according to above chart.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for 1GR-FE)
    B
    NG (for 2TR-FE)
    C



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE