Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2784    Antenna Coil Open / Short

for Preparation Click here


DESCRIPTION

The transponder key coil receives key code signals from key's transponder chip. The coil is built into the transponder key amplifier, which amplifies the key code signals and output the signals to the transponder key ECU.

DTC No.
DTC Detection Condition
Trouble Area
B2784
Open or short in antenna coil circuit
  1. Transponder key amplifier
  2. Wire harness and connector
  3. Transponder key ECU assembly

WIRING DIAGRAM


B121682E01


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (TRANSPONDER KEY COIL)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch ON with the key that cannot start the engine.

  1. On the Techstream, enter the following menus: Body Electrical / Immobiliser / Data List / Antenna Coil Status. Read the values.


Transponder key ECU assembly 
Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
Antenna Coil Status
Transponder key coil condition / Normal or Fail
Normal: Transponder key coil is normal
Fail: Transponder key coil is malfunctioning
-

OK:
"Normal" (Transponder key coil is normal) appears on the screen.



OK
REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)
NG


2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - TRANSPONDER KEY AMPLIFIER)


    B087953E06
  1. Disconnect the T10 ECU connector.

  1. Disconnect the T9 amplifier connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T10-14 (VC5) - T9-1 (VC5)
    Below 1Ω
    T10-15 (CODE) - T9-4 (CODE)
    Below 1Ω
    T10-4 (TXCT) - T9-5 (TXCT)
    Below 1Ω
    T10-5 (AGND) - T9-7 (AGND)
    Below 1Ω
    T10-14 (VC5) or T9-1 (VC5) - Body ground
    10 kΩ or higher
    T10-15 (CODE) or T9-4 (CODE) - Body ground
    10 kΩ or higher
    T10-4 (TXCT) or T9-5 (TXCT) - Body ground
    10 kΩ or higher
    T10-5 (AGND) or T9-7 (AGND) - Body ground
    10 kΩ or higher

  1. Reconnect the ECU connector.

  1. Reconnect the amplifier connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY AMPLIFIER (Click here)