DTC P0115 Engine Coolant Temperature Circuit |
DTC P0117 Engine Coolant Temperature Circuit Low Input |
DTC P0118 Engine Coolant Temperature Circuit High Input |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0115 | An open or short in the engine coolant temperature sensor circuit for 0.5 seconds (1 trip detection logic). |
|
| P0117 | A short in the engine coolant temperature sensor circuit for 0.5 seconds (1 trip detection logic). |
|
| P0118 | An open in the engine coolant temperature sensor circuit for 0.5 seconds (1 trip detection logic). |
|
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| Higher than 135°C (275°F) | Short circuit |
| Related DTCs | P0115: Engine Coolant Temperature Sensor Range Check (Fluctuating) P0117: Engine Coolant Temperature Sensor Range Check (Low Voltage) P0118: Engine Coolant Temperature Sensor Range Check (High Voltage) |
| Required Sensors/Components (Main) | Engine coolant temperature sensor |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 0.5 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| Engine coolant temperature sensor voltage | Less than 0.14 V or more than 4.91 V |
| Engine coolant temperature sensor voltage [Engine coolant temperature] | Less than 0.14 V [Higher than 135°C (275°F)] |
| Engine coolant temperature sensor voltage [Engine coolant temperature] | More than 4.91 V [Below -60°C (-76°F)] |
| Engine coolant temperature sensor voltage [Engine coolant temperature] | 0.14 V to 4.91 V [-60 to 135°C (-76 to 275°F)] |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ VALUE USING TECHSTREAM (ENGINE COOLANT TEMPERATURE) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp.
Read the value displayed on the Techstream.
| Result | Proceed to |
| -40°C (-40°F) | A |
| Higher than 135°C (275°F) | B |
| Between 75°C and 100°C (167°F and 212°F) | C |
|
| ||||
|
| ||||
| A | |
| 2.READ VALUE USING TECHSTREAM (CHECK FOR OPEN IN WIRE HARNESS) |
![]() |
Disconnect the engine coolant temperature sensor connector.
Connect terminals E2-1 and E2-2 of the engine coolant temperature sensor connector on the wire harness side.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp.
Read the value displayed on the Techstream.
| *1 | Engine Coolant Temperature Sensor |
| *2 | ECM |
| *a | Front view of wire harness or connector (to Engine Coolant Temperature Sensor) |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (ENGINE COOLANT TEMPERATURE SENSOR - ECM) |
Disconnect the engine coolant temperature sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E2-2 - E4-32 (THW) | Always | Below 1 Ω |
| E2-1 - E4-28 (E2) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 4.READ VALUE USING TECHSTREAM (CHECK FOR SHORT IN WIRE HARNESS) |
![]() |
Disconnect the engine coolant temperature sensor connector.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp.
Read the value displayed on the Techstream.
| *1 | Engine Coolant Temperature Sensor |
| *2 | ECM |
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (ENGINE COOLANT TEMPERATURE SENSOR - ECM) |
Disconnect the engine coolant temperature sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E2-2 or E4-32 (THW) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||