CAN COMMUNICATION SYSTEM > ECM Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| ECM Communication Stop Mode |
|
|


| 1.PRECAUTION |
| NEXT | |
| 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
| NEXT | |
| 3.SYSTEM CHECK |
Check the vehicle specifications.
| Result | Proceed to |
| for 1GR-FE | A |
| for 2TR-FE | B |
|
| ||||
| A | |
| 4.CHECK FOR OPEN IN CAN BUS WIRE (ECM MAIN WIRE) |
Turn the ignition switch off.
![]() |
Disconnect the E14 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E14-32 (CANH) - E14-31 (CANL) | Ignition switch off | 108 to 132 Ω |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (ECM - BATTERY AND BODY GROUND) |
Connect the cable to the negative (-) battery terminal.
![]() |
Disconnect the E11 and E13 ECM connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E11-12 (E1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E14-21 (IGSW) - Body ground | Ignition switch ON | 11 to 14 V |
| E13-22 (+B) - Body ground | Ignition switch ON | 11 to 14 V |
| E13-23 (+B2) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||
| 6.CHECK FOR OPEN IN CAN BUS WIRE (ECM MAIN WIRE) |
Turn the ignition switch off.
![]() |
Disconnect the E7 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E7-33 (CANH) - E7-34 (CANL) | Ignition switch off | 108 to 132 Ω |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | |
| 7.CHECK HARNESS AND CONNECTOR (ECM - BATTERY AND BODY GROUND) |
Connect the cable to the negative (-) battery terminal.
![]() |
Disconnect the E4 and E8 ECM connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E4-3 (E1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E8-9 (IGSW) - Body ground | Ignition switch ON | 11 to 14 V |
| E8-1 (+B) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||