Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster)

DTC    C1203    ECM Communication Circuit Malfunction

for Preparation Click here


DESCRIPTION

The circuit is used to send TRAC and VSC control information from the skid control ECU to the ECM, and engine control information from the ECM to the skid control ECU through the CAN communication system.

DTC Code
DTC Detection Condition
Trouble Area
C1203
Engine, drive source and destination variations that are sent from the ECM do not match the ones of the skid control ECU.
ECM

INSPECTION PROCEDURE

1.CHECK PART NUMBER (ECM AND BRAKE ACTUATOR ASSEMBLY)
  1. Check that the proper ECM and brake actuator assembly (skid control ECU) are installed.
    Result 
    Result
    Proceed to
    Proper ECUs are not installed
    A
    Proper ECUs are installed
    (for 2TR-FE)
    B
    Proper ECUs are installed
    (for 1GR-FE)
    C



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)
A

REPLACE ECUS WITH PROPER ONES