Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DIAGNOSIS SYSTEM
  1. Warning light and indicator

    1. When there is a problem with the tire pressure warning system, the tire pressure warning light blinks at 0.5 second intervals, and illuminates after 1 minute.

      NOTICE:
      When the malfunction has been corrected, the tire pressure warning light does not illuminate or blink.

  2. DTCs (Normal mode)

    1. DTCs are memorized in the tire pressure warning ECU and read by the blinks of the tire pressure warning light or by using the Techstream (Click here).

  3. Test mode

    1. By switching from normal mode into test mode (input signal check), you can inspect the tire pressure warning antenna and receiver, each tire pressure warning valve and transmitter, engine speed signal and vehicle speed sensor (Click here).


CHECK WARNING LIGHT
  1. Turn the ignition switch to ON.

  2. Check that the tire pressure warning light illuminates for 3 seconds.
    If the warning check result is not normal, proceed to the troubleshooting for the tire pressure warning light circuit.
    Trouble Area
    See page
    Tire pressure warning light circuit
    Click here


TIRE PRESSURE WARNING LIGHT CHART

HINT:
The table below indicates the state of the tire pressure warning light after the ignition switch is turned ON.

Condition
Immediately after turning the ignition switch ON
Always
Warning light output pattern
Illuminates for 3 seconds
Goes off
Illuminates
Blinks for 1 minute and then illuminates (*1)
Blinks (*2)
Blinks (*3)
Blinks (*4)
DTC output
Normal
○
○
-
-
-
-
-
-
Low tire pressure
○
-
○
-
-
-
-
-
System failure
○
-
-
○
-
-
-
-
Test mode
○
-
-
-
○
-
-
-
Initialization
○
-
-
-
-
○
-
-
ECU connector poorly connected
-
-
-
○(*5)
-
-
-
-
TC ground (DTC is output)
○
-
-
-
-
-
-
○
TC ground (DTC is not output)
○
-
-
-
-
-
○
-

  1. *1: Blinks repeatedly at 0.5 second intervals, and illuminates after 1 minute.
  2. *2: Blinks repeatedly at 0.125 second intervals.
  3. *3: Blinks 3 times (1 second on, 1 second off).
  4. *4: Blinks repeatedly at 0.25 second intervals.
  5. *5: When there is an open circuit, the light is off for 10 seconds. Then it blinks at 0.5 second intervals, and illuminates after 1 minute.