Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Light Circuit

for Preparation Click here


DESCRIPTION

If the tire pressure warning ECU detects a disconnected connector or an open circuit between the tire pressure warning ECU and combination meter, the tire pressure warning light is off for 10 seconds after the ignition switch is turned ON. Then, the light blinks for 1 minute, and remains on.

WIRING DIAGRAM


C172828E03


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU and/or the tire pressure warning valve and transmitter has been replaced.

1.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECU)


    C173367E02
  1. Disconnect the T14 ECU connector.

  1. Disconnect the C9 meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    T14-5 (IND) - C9-23
    Always
    Below 1 Ω
    C9-23 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT COMBINATION METER


    C176474E01
  1. Disconnect the connector from the tire pressure warning ECU.

  1. Turn the ignition switch ON, and check the tire pressure warning light illumination condition.
    Result 
    Result
    Proceed to
    Blinks for 1 minute, and then remains on
    A
    Goes off for 3 seconds and then remains illuminated.
    B



B
REPLACE COMBINATION METER ASSEMBLY (Click here)
A

CHECK ECU POWER SOURCE CIRCUIT (Click here)