Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Reset Switch Circuit

for Preparation Click here


DESCRIPTION

Initialization can be started by pressing the tire pressure warning reset switch and holding it for 3 seconds or more.
If the ECU receives the signal from the switch, the tire pressure warning light blinks 3 times (1 second on, 1 second off).

WIRING DIAGRAM


C140098E26


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using the Techstream and note down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU and/or the tire pressure warning valve and transmitter has been replaced.

1.CHECK TIRE PRESSURE WARNING RESET SWITCH FUNCTION
  1. Perform the tire pressure warning reset switch test in TEST MODE PROCEDURE (Click here).

    OK:
    Reset switch ON:
    Tire pressure warning light turns on.
    Reset switch OFF:
    Tire pressure warning light blinks.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT TIRE PRESSURE WARNING RESET SWITCH


    C158396E01
  1. Remove the tire pressure warning reset switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher



NG
REPLACE TIRE PRESSURE WARNING RESET SWITCH
OK


3.CHECK HARNESS AND CONNECTOR (RESET SWITCH - ECU AND BODY GROUND)


    E136996E08
  1. Disconnect the T15 reset switch connector.

  1. Disconnect the T14 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    T14-1 (CLSW) - T15-1
    Always
    Below 1 Ω
    T14-1 (CLSW) - Body ground
    Always
    10 kΩ or higher
    T15-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TIRE PRESSURE WARNING ECU (Click here)