Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Front Passenger Side Seat Belt Warning Light Malfunction

for Preparation Click here


DESCRIPTION

  1. When the ignition switch is ON and the front passenger seat is occupied, the occupant classification ECU communicates the status of the front seat inner belt assembly (passenger side) to the airbag sensor assembly. The combination meter assembly receives signals from the airbag sensor assembly and transmits them to the integration control and panel assembly. When the seat belt is unfastened, the combination meter assembly flashes the front passenger seat belt warning light on the hazard warning signal switch. When the seat belt is fastened, the combination meter assembly stops flashing the front passenger seat belt warning light on the hazard warning signal switch.

WIRING DIAGRAM


E231219E01


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK SUPPLEMENTAL RESTRAINT SYSTEM
  1. Check if a supplemental restraint DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO SUPPLEMENTAL RESTRAINT SYSTEM (Click here)
A


3.CHECK OCCUPANT CLASSIFICATION SYSTEM
  1. Check if a occupant classification DTC is output.

    1. for Bench Seat Type (Click here)
    2. for Separate Seat Type (Click here)
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for Bench Seat Type)
    B
    DTC is output (for Separate Seat Type)
    C



B
GO TO OCCUPANT CLASSIFICATION SYSTEM (Click here)

C
GO TO OCCUPANT CLASSIFICATION SYSTEM (Click here)
A


4.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - HAZARD WARNING SIGNAL SWITCH)
  1. Disconnect the C9 combination meter assembly connector.

  1. Disconnect the H7 hazard warning signal switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C9-5 - H7-8 (PBEW)
    Always
    Below 1 Ω
    C9-5 or H7-8 (PBEW) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the hazard warning signal switch connector.

  1. Reconnect the combination meter assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.INSPECT COMBINATION METER ASSEMBLY


    I044513E18
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    C9-5 - Body ground
    Ignition switch ON
    Front passenger seat occupied
    Alternating between 11 to 14 V and below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Combination Meter Assembly)



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE HAZARD WARNING SIGNAL SWITCH ASSEMBLY