DTC B2796 No Communication in Immobiliser System |
DTC B2798 Communication Malfunction No. 2 |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| B2796 | No Communication |
|
| B2798 | Communication error | Key |

| 1.READ VALUE USING TECHSTREAM (ENGINE IMMOBILISER SYSTEM) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON with the key that cannot start the engine.
On the Techstream enter the following menus: Body Electrical / Immobiliser / Data List / Immobiliser. Read the values.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| Immobiliser | Immobiliser system status / Set or Unset | Unset: Ignition switch ON Set: Without key | - |
|
| ||||
| NG | |
| 2.CHECK WHETHER ENGINE STARTS WITH OTHER KEYS |
Check whether the engine starts with the vehicle's other keys.
|
| ||||
| NG | |
| 3.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch ON with the key that will not start the engine.
On the Techstream, enter the following menus: Body Electrical / Immobiliser / Data List / Antenna Coil Status. Read the values.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| Antenna Coil Status | Transponder key coil condition / Normal or Fail | Normal: Transponder key coil is normal Fail: Transponder key coil is malfunctioning | - |
|
| ||||
| NG | |
| 4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - TRANSPONDER KEY AMPLIFIER) |
![]() |
Disconnect the T10 ECU connector.
Disconnect the T9 amplifier connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| T10-14 (VC5) - T9-1 (VC5) | Below 1Ω |
| T10-15 (CODE) - T9-4 (CODE) | Below 1Ω |
| T10-4 (TXCT) - T9-5 (TXCT) | Below 1Ω |
| T10-5 (AGND) - T9-7 (AGND) | Below 1Ω |
| T10-14 (VC5) or T9-1 (VC5) - Body ground | 10 kΩ or higher |
| T10-15 (CODE) or T9-4 (CODE) - Body ground | 10 kΩ or higher |
| T10-4 (TXCT) or T9-5 (TXCT) - Body ground | 10 kΩ or higher |
| T10-5 (AGND) or T9-7 (AGND) - Body ground | 10 kΩ or higher |
Reconnect the ECU connector.
Reconnect the amplifier connector.
|
| ||||
| OK | |
| 5.REPLACE TRANSPONDER KEY AMPLIFIER (OPERATION) |
After replacing the transponder key amplifier with a normally functioning amplifier (Click here), check that the engine starts.
|
| ||||
| OK | ||
| ||