Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2797    Communication Malfunction No. 1

for Preparation Click here


DESCRIPTION

This DTC is output when a communication error occurs between the transponder key amplifier and transponder key ECU. Some possible reasons for the communication error are: 1) 2 or more ignition keys are positioned too close together, or 2) noise is occurring in the communication line.

DTC No.
DTC Detection Conditions
Trouble Areas
B2797
Keys are positioned too close each other, or noise occurred in communication line
  1. Key
  2. Wire harness and connector
  3. Transponder key amplifier
  4. Transponder key ECU assembly

WIRING DIAGRAM


B121683E01


INSPECTION PROCEDURE

1.CHECK KEYS


    B072873E01
  1. Check if the ignition key being used is near other ignition keys, as shown in the illustration. Also, check if the key ring is in contact with the key grip.
    Result 
    Result
    Proceed to
    The key is near other keys and/ or the key rings is in contact with key grip.
    A
    The key is not near other keys and/or the key ring is not in contact with the key grip.
    B



B
Go to step 3
A


2.CHECK FOR DTCS
  1. Separate the keys from each other and/or remove the key ring.

  1. Delete the DTC (Click here).

  1. Insert a key into the ignition cylinder. Remove it. Repeat for all the other keys.

  1. Check that no code is output.

    OK:
    No code is output.



OK
NORMAL (INSPECTION FINISHED)
NG


3.CHECK TRANSPONDER KEY ECU ASSEMBLY


    B110405E03
  1. Using an oscilloscope or the Techstream, check for noise in the waveform between the terminals of the T9 amplifier connector and T10 ECU connector.

    OK:
    No noise is present (see illustration).

    Tester Connection
    Specified Condition
    T10-15 (CODE) - T9-4 (CODE)
    No noise is present
    Tool Setting
    5 V/div. 20 ms/DIV.
    Condition
    Ignition switch:
    OFF → ON



NG
FIND CAUSE OF NOISE AND REMOVE IT
OK


4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - TRANSPONDER KEY AMPLIFIER)


    B087953E05
  1. Disconnect the T10 ECU connector.

  1. Disconnect the T9 amplifier connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T10-15 (CODE) - T9-4 (CODE)
    Below 1Ω

  1. Reconnect the ECU connector.

  1. Reconnect the amplifier connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE TRANSPONDER KEY AMPLIFIER (OPERATION)
  1. After replacing the transponder key amplifier with a normally functioning amplifier (Click here), check that the engine starts.

    OK:
    Engine starts.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)
OK

END (TRANSPONDER KEY AMPLIFIER DEFECTIVE)