DTC 01-D6 No Master |
DTC 01-D7 Connection Check Error |
| DTC No. | DTC Detection Condition | Trouble Area |
| 01-D6*1 | Either condition is met:
|
|
| 01-D7*2 | Either condition is met:
|
| 1.CHECK RADIO RECEIVER ASSEMBLY POWER SOURCE CIRCUIT |
| NEXT | |
| 2.IDENTIFY COMPONENT WHICH HAS STORED THIS CODE |
Enter diagnostic mode.

Press preset switch "2" to change the mode to "Detailed Information Mode".
Identify the component which has stored this code.
| Component | Physical Address |
| Multi-media interface ECU | 388 |
| Satellite radio tuner | 1F1 |
| NEXT | |
| 3.CHECK COMPONENT SHOWN BY SUB-CODE |
Select the component shown by the sub-code.
| Component | Proceed to |
| Except satellite radio tuner | A |
| Satellite radio tuner (1F1) | B |
|
| ||||
| A | |
| 4.CHECK POWER SOURCE CIRCUIT OF COMPONENT WHICH HAS STORED THIS CODE |
Inspect the power source circuit of the component which has stored this code.
If the power source circuit is operating normally, proceed to the next step.
| Component | Proceed to |
| Multi-media interface ECU | Multi-media interface ECU power source circuit (Click here) |
| NEXT | |
| 5.INSPECT RADIO RECEIVER ASSEMBLY |
![]() |
Disconnect the R14 radio receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R14-9 (TXM+) - R14-10 (TXM-) | Always | 60 to 80 Ω |
| *a | Component without harness connected (Radio Receiver Assembly) |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR |
Referring to the following AVC-LAN wiring diagram, check the AVC-LAN circuit between the radio receiver assembly and component which has stored this code.
Disconnect all connectors between the radio receiver assembly and component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the radio receiver assembly and component which has stored this code.

|
| ||||
| OK | |
| 7.REPLACE COMPONENT WHICH HAS STORED THIS CODE |
Replace the component which has stored this code with a known good one.
| NEXT | |
| 8.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 9.RECHECK FOR DTC |
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||