Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > AVC-LAN Circuit

for Preparation Click here


DESCRIPTION

Each audio system component connected to the AVC-LAN (communication bus) transfers switch signals using the audio visual communication local area network.
If a short to +B or short to ground occurs in the AVC-LAN, the audio system will not function normally because communication is not possible.

INSPECTION PROCEDURE

NOTICE:
After replacing the radio receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS System).

1.INSPECT RADIO RECEIVER ASSEMBLY


    E232753E01
  1. Disconnect the R14 radio receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R14-9 (TXM+) - R14-10 (TXM-)
    Always
    60 to 80 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Radio Receiver Assembly)



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR

HINT:
For details of the connectors, refer to Terminals of ECU (Click here).



  1. Referring to the following AVC-LAN wiring diagram, check all AVC-LAN circuits.

    1. Disconnect all connectors in all AVC-LAN circuits.



    2. Check for an open or short in all AVC-LAN circuits.

      OK:
      There is no open or short circuit.


      E232752E01



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT MALFUNCTIONING PARTS
  1. Disconnect the slave unit and check if the master unit returns to normal operation.

    HINT:
    If disconnecting the slave unit causes the master unit to return to normal operation, this indicates that the slave unit is malfunctioning. Replace the slave unit.

    OK:
    Master unit returns to normal operation.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE MALFUNCTIONING PARTS