Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)

VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster) > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the ECU to display 2-digit DTCs by blinking the ABS, VSC and TRAC warning lights.

WIRING DIAGRAM


C189640E02


INSPECTION PROCEDURE

1.INSPECT DLC3 (TC TERMINAL VOLTAGE)


    C151827E54
  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D4-13 (TC) - D4-4 (CG)
    Ignition switch ON
    11 to 14 V

  1. Turn the ignition switch off.



NG
Go to step 3
OK


2.CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)  

3.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)


    C151827E55
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D4-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (ECM - DLC3)


    C189641E01
  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D4-13 (TC) - E14-28 (TC)
    Always
    Below 1 Ω
    D4-13 (TC) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK HARNESS AND CONNECTOR (ECM - SKID CONTROL ECU)


    C189642E01
  1. Disconnect the S1 skid control ECU (master cylinder solenoid) connector.

  1. Disconnect the E14 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S1-25 (CANL) - E14-31 (CANL)
    Always
    Below 1 Ω
    S1-11 (CANH) - E14-32 (CANH)
    Always
    Below 1 Ω

  1. Reconnect the ECM connector.

  1. Reconnect the skid control ECU (master cylinder solenoid) connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.CHECK ECM (DLC3 (TC) INPUT)


    C151827E54
  1. Connect terminals TC and CG of DLC3.

  1. Turn the ignition switch to ON.

  1. Check if the ECM warning light is blinking.

    OK:
    ECM warning light is blinking.

  1. Turn the ignition switch off.

  1. Disconnect the TC and CG terminals of DLC3.



NG
REPLACE ECM (Click here)
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)