TIRE PRESSURE WARNING VALVE AND TRANSMITTER > INSTALLATION |
| 1. INSTALL TIRE PRESSURE WARNING VALVE AND TRANSMITTER |
When reusing the tire pressure warning valve and transmitter, install a new grommet to it.
![]() |
Insert the tire pressure warning valve and transmitter from the inside of the rim into the valve installation hole so that the print surface can be seen.
![]() |
Install a new washer and new nut on the tire pressure warning valve and transmitter from the rim side.
Set the wheel disc to a mounting machine and install the lower tire bead. At this time, position the main body of the tire pressure warning valve and transmitter in the shaded area shown in the illustration.

Install the upper bead.
Install the valve core to the tire pressure warning valve and transmitter.
Inflate the tire. If the valve nut is loose after inflating the tire, retighten the nut to the specified torque and then check for air leaks with soapy water.
Set the air pressure of the tires to the specified values.
Install the cap to the tire pressure warning valve and transmitter.
| 2. INSTALL FRONT WHEEL |
| 3. INSTALL REAR WHEEL |
| 4. PERFORM REGISTRATION OF TRANSMITTER ID |
Register the transmitter ID (Click here).
| 5. PERFORM INITIALIZATION (for Tire Pressure Warning System) |
When the valve and transmitter is replaced, perform initialization (Click here).
| 6. CHECK TIRE PRESSURE AFTER REPAIRS |
After repairs, confirm that the actual tire pressures are displayed in the Data List (Click here).