OCCUPANT CLASSIFICATION ECU (for Bench Seat Type) > INSTALLATION |
| 1. INSTALL OCCUPANT CLASSIFICATION ECU |
![]() |
Check that the ignition switch is OFF.
Check that the negative battery (-) terminal is disconnected.
Install the occupant classification ECU with the 2 bolts.
Connect the connector to the occupant classification ECU.
| 2. INSTALL FRONT SEAT ASSEMBLY |
![]() |
Place the front seat in the cabin.
Slide the front seat to the most rearward position.
Tighten the 2 bolts on the front side.
Slide the front seat to the most forward position.
Tighten the 2 bolts on the rear side.
![]() |
Install the 2 wiring harness clamps.
Connect the 5 connectors.
![]() |
Install the belt of the front center seat outer belt into the front center seat outer belt guide.
| 3. INSTALL FRONT SEAT HEADREST ASSEMBLY |
![]() |
Push in the 2 lock buttons of the 2 front seat headrest supports and install the 2 front seat headrests.
| 4. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH |
![]() |
Slide the front seat to the most forward position.
Install the front seat inner belt with the bolt.
Install the 2 wiring harness clamps.
Connect the 2 connectors.
Engage the hook.
| 5. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH |
![]() |
Slide the front seat to the most forward position.
Install the front seat inner belt with the bolt.
Install the 2 wiring harness clamps.
Connect the connector.
Engage the hook.
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. INSERT OCCUPANT CLASSIFICATION ECU DATA |
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Store the occupant classification ECU data into the Techstream by following the prompts on the Techstream screen.
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Replace the occupant classification ECU (Click here).
Connect the negative (-) terminal cable to the battery.
Turn the ignition switch to the ON position.
Load the data from the previous ECU stored in the Techstream, into the newly installed ECU by following the prompts on the Techstream screen.
Turn the ignition switch to the LOCK position.
Turn the ignition switch to the ON position.
Clear the DTCs stored in the memory (Click here).
| 8. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK |
| 9. INSPECT SRS WARNING LIGHT |