DTC B1797 Calibration Malfunction |
| Item | Condition |
| DTC | Not recorded. |
| Front passenger seat occupant. | Vacant |
| Front passenger side buckle switch. | OFF (The seat belt is not fastened) |
| ECU temperature | 0 to 46°C (32 to 114.8°F) |
| Filtered pressure | 38 to 75 count |
| DTC No. | DTC Detecting Condition | Trouble Area |
| B1797 |
|
|
| 1.CHECK DTC |
Turn the ignition switch to the ON position.
Clear the DTCs stored in the memory (Click here).
Turn the ignition switch to the LOCK position.
Turn the ignition switch to the ON position, and wait for at least 10 seconds.
Check the DTCs (Click here).
|
| ||||
| YES | |
| 2.READ VALUE USING DATA LIST (SPECIFIED CONDITION FOR ZERO POINT CALIBRATION) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON position.
Using the Techstream, read the Data List (Click here).
| Item | Measurement Item/ Range (Display) | Normal Condition | Specified Condition for Zero Point Calibration |
| Pressure sensor output | Pressure sensor output/ Min.: 0 Max.: 255 | 0 to 210 (reference value) | 0 to 2 |
| Thermistor temperature output | Thermistor temperature output/ Min.: -40°C (-40°F) Max.: 90°C (194°F) | -40 to 85°C (-40 to 185°F) | 3 to 40°C (36 to 104°F) |
| Number of Present DTC | Number of present trouble codes/ Min.: 0 Max.: 255 | 0 | 0 |
| Number of Past DTC | Number of past trouble codes/ Min.: 0 Max.: 255 | 0 | 0 |
| Result | Proceed to |
| All items correspond to the range of specified condition for zero point calibration. | A |
| THERMISTOR TEMP does not correspond to the range of specified condition for zero point calibration. | B |
|
| ||||
| A | |
| 3.CHECK DTC |
Turn the ignition switch to the ON position.
Clear the DTCs stored in the memory (Click here).
Turn the ignition switch to the LOCK position.
Turn the ignition switch to the ON position.
Check the DTCs (Click here).
| NEXT | |
| 4.PERFORM ZERO POINT CALIBRATION |
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Using the Techstream, perform the zero point calibration (Click here).
Turn the ignition switch to the OFF position.
Turn the ignition switch to the ON position.
Clear the DTCs stored in the memory (Click here).
| NEXT | |
| 5.CHECK DTC |
Turn the ignition switch to the ON position.
Clear the DTCs stored in the memory (Click here).
Turn the ignition switch to the LOCK position.
Turn the ignition switch to the ON position.
Check the DTCs (Click here).
| NEXT | ||
| ||
| 6.REPLACE FRONT SEAT CUSHION ASSEMBLY (WITH OCCUPANT CLASSIFICATION SENSOR AND SENSOR) |
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Replace the front seat cushion assembly (with occupant classification sensor and ECU) (Click here).
Connect the negative (-) terminal cable to the battery.
Turn the ignition switch to the ON position.
Clear the DTCs stored in the memory (Click here).
Turn the ignition switch to the LOCK position.
Turn the ignition switch to the ON position.
Using the Techstream, check the DTCs of the occupant classification ECU (Click here).
| NEXT | ||
| ||