Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Satellite Radio Tuner Communication Error

for Preparation Click here


INSPECTION PROCEDURE

NOTICE:
After replacing the radio receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS System).

1.IDENTIFY COMPONENT SHOWN BY SUB-CODE


  1. Enter diagnostic mode.


    E110917E24

  1. Press preset switch "2" to change to "Detailed Information Mode".

  1. Identify the component shown by the sub-code.

    HINT:
    1. The sub-code "P190" shown in the above example indicates the radio receiver assembly.
    2. For details of the DTC display, refer to DTC Check/Clear (Click here).


NEXT


2.CHECK COMPONENT SHOWN BY SUB-CODE
  1. Select the component shown by sub-code.

    HINT:
    The satellite radio tuner is built into the radio receiver assembly. If there is a problem between the satellite radio tuner and radio receiver assembly, replace the radio receiver assembly.


    Component Table 
    Component
    Proceed to
    Except radio receiver assembly
    A
    Radio receiver assembly (190)
    B



B
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
A


3.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.
    If the power source circuit is operating normally, proceed to the next step.

    Component Table 
    Component
    Proceed to
    Multi-media interface ECU (388)
    Multi-media interface ECU power source circuit (Click here)


NEXT


4.INSPECT RADIO RECEIVER ASSEMBLY


    E232753E01
  1. Disconnect the R14 radio receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R14-9 (TXM+) - R14-10 (TXM-)
    Always
    60 to 80 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Radio Receiver Assembly)



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


5.CHECK HARNESS AND CONNECTOR (SATELLITE RADIO TUNER - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  2. For details of the connectors, refer to Terminals of ECU (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the radio receiver assembly (built-in satellite radio tuner) and component shown by the sub-code.

    1. Disconnect all connectors between the radio receiver assembly (built-in satellite radio tuner) and component shown by the sub-code.



    2. Check for an open or short in the AVC-LAN circuit between the radio receiver assembly (built-in satellite radio tuner) and component shown by the sub-code.

      OK:
      There is no open or short circuit.


      E232752E01



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a known good one and check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
REPLACE RADIO RECEIVER ASSEMBLY (BUILT-IN SATELLITE RADIO TUNER) (Click here)
OK

END