DTC P0607 Control Module Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0607 |
|
|
| Related DTCs | P0607: Control Module Performance |
| Required sensors/Components (Main) | ECM |
| Required sensors/Components (Related) | Heated oxygen sensor |
| Frequency of operation | Continuous |
| Duration | 60 seconds |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever the following are not present | None |
| Engine | Running |
| Estimated heated oxygen sensor temperature | 450 to 800°C (842 to 1472°F) |
| Heated oxygen sensor transistor | Fail |

| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTCS OUTPUT |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| DTC P0607 and P0136, P0137 or P0138 are output | A |
| Only DTC P0607 is output | B |
|
| ||||
| A | |
| 2.INSPECT DTC (DTC P0136, P0137 OR P0138) |
Inspect the P0136, P0137 or P0138 flowchart.
|
| ||||
| 3.CHECK EXHAUST GAS LEAK |
Allow the engine to idle and rev the engine.
Check for exhaust gas leaks around the heated oxygen sensor.
If any exhaust gas leaks are present, repair them and proceed to "Perform Confirmation Driving Pattern". If no exhaust gas leaks are present, proceed to "Perform Confirmation Driving Pattern".
| NEXT | |
| 4.PERFORM CONFIRMATION DRIVING PATTERN |

Clear DTC (Click here).
Connect the Techstream to the DLC3.
Start the engine.
Turn the Techstream on.
Warm up the engine until the engine coolant temperature becomes 75°C (167°F) or more.
Perform the drive pattern.
Accelerate the vehicle to 50 mph (80 km/h) and stop the vehicle.
Drive the vehicle between 35 and 50 mph (60 and 80 km/h) for 5 minutes.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| DTC P0607 and P0136, P0137 or P0138 are output | A |
| Only DTC P0607 is output | B |
| No DTC is output | C |
|
| ||||
|
| ||||
| A | |
| 5.INSPECT DTC (DTC P0136, P0137 OR P0138) |
Inspect the P0136, P0137 or P0138 flowchart.
| NEXT | |
| 6.INSPECT ECM |
Clear DTC (Click here).
Stop the engine and wait for 30 minutes.
Connect the Techstream to the DLC3.
Start the engine and allow it to idle for 2 minutes.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P0607 is output | B |
|
| ||||
| A | ||
| ||