DTC P0606 ECM Processor |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0606 | There is an ECM main CPU error (1 trip detection logic). | ECM |
| Related DTCs | P0606: ECM range check |
| Required sensors/Components (Main) | ECM |
| Required sensors/Components (Related) | - |
| Frequency of operation | Continuous |
| Duration | Within 1 second |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not present | None |
| Either condition A or B is met | - |
| A. DMA communication | No response |
| B. Watchdog from monitoring processor | Not toggle |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear DTCs (Click here).
Turn the ignition switch off and turn the Techstream off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Wait 1 second or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
|
| ||||
| OK | ||
| ||