DTC P0657 Actuator Supply Voltage Circuit / Open |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0657 | Throttle actuator power supply error (1 trip detection logic) | ECM |
| Related DTCs | P0657: ETCS Power Supply |
| Required sensors/Components (Main) | ECM |
| Required sensors/Components (Related) | Throttle actuator |
| Frequency of operation | Once per driving cycle |
| Duration | Within 1 second |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not present | None |
| Throttle actuator power supply | 7 V or higher |
| Electronic throttle actuator power supply | ON |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear DTCs (Click here).
Turn the Techstream off.
Turn the ignition switch off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch to ON.
Wait 10 seconds or more.
Turn the ignition switch off.
Wait 15 seconds or more.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Wait 5 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
|
| ||||
| OK | ||
| ||