DTC P0606 ECM / PCM Processor |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0606 | When either condition below is met (1 trip detection logic):
| ECM |
| Related DTCs | P0606: ECM processor performance |
| Required sensors / components (Main) | ECM |
| Required sensors / components (Related) | Throttle actuator (throttle with motor body assembly) |
| Frequency of operation | Continuous |
| Duration | Within 1 second |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not stored | None |
| Either of following condition a or b met | - |
| a. DMA communication | No response |
| b. Watchdog from Monitoring Processor | Not toggle |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P0606) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear DTC (Click here).
Turn the ignition switch off and turn the Techstream off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Wait 1 second or more.
Enter the following menus: Powertrain / Engine and ECT/ Trouble Codes.
Read DTCs.
|
| ||||
| OK | ||
| ||