DTC P060A Internal Control Module Monitoring Processor Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060A | When any condition below is met (1 trip detection logic):
| ECM |
| Related DTCs | P060A: Internal control module monitoring processor performance |
| Required sensors / components (Main) | ECM |
| Required sensors / components (Related) | - |
| Frequency of operation | Continuous |
| Duration | - |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not stored | None |
| When either condition below is met: | Condition 1 or 2 |
| 1. When all conditions below are met: | - |
| - CPU reset | 1 time or more |
| - Learned TP - Learned APP | 0.4 V or more |
| - Electronic throttle actuator | OFF |
| 2. CPU reset | 2 times or more |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P060A) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear DTC (Click here).
Turn the ignition switch off and turn the Techstream off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Wait 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT/ Trouble Codes.
Read DTCs.
|
| ||||
| OK | ||
| ||