DTC P060D Internal Control Module Accelerator Pedal Position Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060D | There is an ECM main CPU error (1 trip detection logic). | ECM |
| Related DTCs | P060D: Internal Control Module, Accelerator Pedal Position |
| Required sensors/Components (Main) | ECM |
| Required sensors/Components (Related) | - |
| Frequency of operation | Continuous |
| Duration | 1 second |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not present | None |
| Difference of main accelerator pedal position and sub accelerator pedal position | 0.3 V or higher |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear DTC (Click here).
Turn the ignition switch off and turn the Techstream off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Wait 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT/ Trouble Codes.
Read DTCs.
|
| ||||
| OK | ||
| ||