DTC P060B Internal Control Module A/D Processing Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060B | ECM main CPU communication error (1 trip detection logic) |
|
| Related DTCs | P060B: Internal control module A/D processing performance |
| Required sensors / components (Main) | ECM |
| Required sensors / components (Related) | - |
| Frequency of operation | Once per driving cycle |
| Duration | 2 times: AD converter is fail (Case 2) 30 times: Knock sensor circuit is fail (Case 3, 4) 10 times: Internal control module serial communication is fail (Case 1) |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not stored | None |
| Both of the following conditions are met | - |
| Battery voltage | 8 V or higher |
| Starter | OFF |
| Monitor runs whenever following DTCs not stored | None |
| Internal control module serial communication | Fail |
| AD Converter | Fail |
| Knock sensor circuit | Fail |
| Knock control sensor serial communication | Fail |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P060B) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear DTC (Click here).
Turn the ignition switch off and turn the Techstream off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Wait 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT/ Trouble Codes.
Read DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P060B is output | B |
| DTC P060B and P0327, P0328, P0332 or P0333 are output | C |
|
| ||||
|
| ||||
| A | ||
| ||