DTC P1607 Cruise Control Input Processor |
| DTC No. | DTC Detection Condition | Trouble Area |
| P1607 | ECM CPUs malfunction (1 trip detection logic) | ECM |
| Related DTC | P1607: Internal control module range check |
| Required sensors/Components (Main) | ECM |
| Required sensors/Components (Related) | Cruise control |
| Frequency of Operation | Continuous |
| Duration | 0.3 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not stored | None |
| DMA communication error | Not detected |
| Cruise control | Forbiddance |
| Either of the following conditions is met | A or B |
| A, Cruise control | Operating |
| B, Low speed control | Operating |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P1607) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear DTC (Click here).
Turn the ignition switch off and turn the Techstream off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Wait 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT/ Trouble Codes.
Read DTCs.
|
| ||||
| OK | ||
| ||